Wiring Guide for tinkerBOY Controller v2.0.1
7 thoughts on “Wiring Guide for tinkerBOY Controller v2.0.1”
Leave a Reply
This site uses Akismet to reduce spam. Learn how your comment data is processed.
This site uses Akismet to reduce spam. Learn how your comment data is processed.
Is there a way to wire the 5 pin volume wheel to this board? I bought this board from you but have the 5 pin volume wheel. Thanks!
hm so you don’t need to connect ‘data’ cables? only power? is that right?
What data cables? This controller is not USB based but GPIO based controller.
I understand that the controller is GPIO based but those run off 3.3v. Is it save to assume the pads for the controller buttons have resistors to lower the 5.5v input voltage on the board down to 3.3v?
This controller was designed for the Raspberry Pi with 3.3V gpio already and resistors are also built in so no need for them.
Will this also work on GPIO 12?
https://raspberrypi.stackexchange.com/questions/49600/how-to-output-audio-signals-through-gpio
This looks really cool! Can you tell me how I could use this with the DE-10 Nano (MiSTer fpga). Is it possible?